Jeti

Jeti receivers connect over EX Bus, which carries control and telemetry on one wire. Rotorflight's telemetry sensors then appear on the radio automatically.

Wiring

Connect the flight controller's receiver port (often labelled SBUS) to an EX Bus capable receiver output -- for example E1 -- with a servo lead.

Receiver

In the radio's Device Explorer, open the receiver and:

1. Select the receiver.
2. Enable the alternative pin configuration if needed, so the chosen output can be set to EX Bus.
3. Set that output (e.g. E1) to EX Bus.

Flight controller

1. Configuration tab: set the port to Serial Rx. Save and reboot.
2. Receiver tab: protocol Jeti EXBUS, and enable telemetry. Save and reboot.

The control link and telemetry should now work, with the selected telemetry sensors listed on the radio.